Hypertherm 105A plasma source cutting parameters
Publish Time: 2020-06-19 Origin: Site
Hypertherm 105A plasma source cutting parameters
| Material | Thickness (mm) | Pierce delay (S) | Arc (V) | Speed (mm/min) |
| Carbon steel | 6 | 0.5 | 144 | 4140 |
| 8 | 0.75 | 145 | 3140 | |
| 10 | 145 | 2260 | ||
| 12 | 145 | 1690 | ||
| 16 | 1 | 149 | 1060 | |
| 20 | 152 | 780 | ||
| Stainless steel | 6 | 0.5 | 139 | 4870 |
| 8 | 141 | 3460 | ||
| 10 | 144 | 2240 | ||
| 12 | 0.6 | 148 | 1490 | |
| 16 | 0.75 | 149 | 950 | |
| 20 | 1.25 | 154 | 660 | |
| Aluminum | 6 | 0.5 | 145 | 5980 |
| 8 | 0.75 | 149 | 4170 | |
| 10 | 152 | 2640 | ||
| 12 | 1 | 156 | 1910 | |
| 16 | 157 | 1290 | ||
| 20 | 1.25 | 163 | 1020 | |
Attention:
1). Above parameters are for reference only.
2). If can not cut through metal,need to slow down the cutting speed.
3). If there are too much slag after cutting, need to speed up the cutting speed.
4). Pay attention to the perforation time.
5). This plasma source need stable 8kg air compressor.
If need 45A,65A,85A,125A,200A Hypertherm plasma machines parameters, please do not hesitate to contact us.